Maryville QuarryMetal/Nonmetal

Employee alleges as EE was climbing up a haul truck ladder EE's foot became stuck in the light hole and caused to lose balance, straining EE's shoulder.

Employee was removing a clamp from a DEF hose on a CAT D8T dozer. The clamp broke loose and the employee felt a pop in EE's right shoulder.

Removing catwalk from conveyor. The conveyor had been set on the ground. Employee cut the bolts holding the catwalk in order to remove it. They then began to remove the remaining pieces of the bolts that were still supporting the catwalk. When the last piece was removed the catwalk shifted and pinned the left hand against the frame of the conveyor.

Injured employee was removing wheel chocks from the wheels of his F150 pick up truck. While placing the chocks in the bed of truck he felt a burning sensation in his right shoulder. Resulting in a strain

Injured employee was washing around the plant using a water hose. He said that the pressure increased and he lost his grip, and the hose struck him in the left knee resulting in a contusion.

A co-worker was hitting a drill bit with a hammer to loosen it from the hammer on the drill. A small piece of metal was knocked off the bit and struck the injured ee in the left forearm causing it to become embedded.

EMPLOYEE WAS HOOKING UP SHOT & SLIPPED ON A HILL (LOOSE ROCKS & MUD) & SPRAINED HIS RIGHT KNEE & ANKLE.

EE WAS IN THE PUGMILL TUNNEL GREASING EQUIPMENT NEAR THE TAIL PULLEY. WHILE WALKING IN TUNNEL HE FELT A PAIN IN HIS LEFT KNEE. DID NOT TWIST KNEE OR STEP ON ANYTHING.

THE EE WAS CUTTING A V BELT WITH A KNIFE AND THE KNIFE SLIPPED AND CUT HIS LEFT THUMB.

THE EE WAS GOING DOWN A LADDER TO WORK ON A FEEDER AT PRIMARY CRUSHER & AS HE STEPPED FROM LADDER, HE STEPPED ON A LOOSE ROCK AND TURNED HIS LEFT ANKLE.