Another company came to tighten a bolt on the quick coupler of a CX350. They tried with a swivel head ratchet on the nut end & an air impact on the head of the bolt. It didn't work. Then switched places & our EE was holding the ratchet with a hand on the head of the bolt & tried to loosen it, the pivot pin in the ratchet broke & smashed EE's left thumb.
While putting a 30' piece of channel frame conveyor into the shop to avoid the rain the straps on one end slid off the forks on the telehandler allowing the end of the conveyor to fall aprox 3' onto an employees left foot.
Employee (Mechanic) was driving seal into hub when he hit the driver with a hammer the hammer bounced striking employees left hand on the skin between the thumb and index finger lacerating a 2cm skin area.
Repairing conveyor belt using homemade belt clamp, when removing clamp, the clamp closed and pinched right ring finger between two pieces of angle iron, lacerating nail area of finger.
While walking down steps with grease gun and oil jug, right knee twisted, causing it to pop out.
WHILE STANDING ON TIRE TO GREASE LOADER EMPLOYEELOST FOOTING ON LOOSE GRAVEL TIRE SLID DOWN TIREONTO GROUND, STRIKING LEFT ELBOW ON CONCRETE. FRACTURED LEFT ELBOW.
ASSISTING MECHANIC, PLACVED 55 GAL DRUM OF OIL IN LOADER BUCKET. TOOKE TO AREA IN SHOP WHERE WORKING ON EQUIPMENT. UNLOADED DRUM. WORK ANOTHER HOUR THEN WENT HOME. DEBVELOPED BURNING SENSATION IN RIGHT THIGH ON WAY HOME. COULD NOT USE LEG VERY WELL THAT NIGHT. WENT TO ER AND TOLD THINKS HE HAS TORN MUSCLE /TENDON.
WHILE TRYING TO BREAK A ROCK WITH SLEDGE HAMMER TO FIT IN CRUSHER, TWISTED HIS BACK.