Cyril Rock QuarryMetal/Nonmetal

EE was lifting a motor and strained his hand. He did not report until 16 July 2010.

Welders were replacing a section of flooring on the catwalk on the east side of the 5X14 screen and had cut an approximate 1' diameter hole. EE stepped onto the hole and lost his balance and fell. He struck his right shoulder on the handrail or screen, fracturing arm bone.

EMPLOYEE WAS USING A HOSE TO CLEAN UNDER THE JAW BELT CONVEYOR WHICH IS TWO FEET OFF THE GROUND. HE WAS STANDING BELOW & TO THE SIDE OF THE HEAD SECTION OF THE 5 1/2 DISCHARGE BELT & THE TAIL SECTION OF THE 5 X 14' CONVEYOR. THE BELTS WERE OPERATING & A ROCK FELL FROM ONE OF THESE BELTS APPROXIMATELY 10' & STRUCK HIS BACK. HE IS LOSING TIME.

EE STRAINED HIS BACK WHILE CHANGING SCREENS ON THE 5X14 DECK.

EE WAS CHANGING SCREENS ON THE 4 X 12 SHAKER. A SCREEN BECAME WEDGED AND WHILE HE WAS ATTEMPTING TO PULL IT LOOSE, HE INJURED HIS LEFT WRIST AND ARM.

EE JUMPED OVER A FOUR FOOT WALL TO GAIN ACCESS TO THE OLD SHOP FLOOR. HE STEPPED ON A BOLT AND TWISTED HIS ANKLE.

ON 7 FEB. 2003, EE COMPLETED AN ACCIDENT REPORT CLAIMING THAT HIS BACK WAS INJURED WHILE OPERATING A QUARRY TRUCK ON 20 JAN. 2003. HE DID NOT SAY ANYTHING ON 01-20-2003 AND WORKED THROUGH 1-28-03. HE TOOK OFF PART OF 1-28-03 AND 1-29-03TO MOVE HIS FAMILY OUT OF THEIR HOUSE. ON 1-30-030 HE COMPLAINED THAT HIS SEAT WAS BOUNCING. A MECH. CHECKED SEAT DROVE THRU 2-3-03 W/O COMPLAIN

EMPLOYEE WAS WORKING WITH OTHER EMPLOYEES TO TAKE THE CRUSHER APART. WHILE PUTTING A HOOK IN A LIFTING EYE, THE HOOK SLIPPED AND SMASHED HIS 4TH FINGER.

EMPLOYEE WAS REMOVING ROCK BY HAND FROM DIS- CHARGE BOX. A ROCK ROLLED AND CAUGHT HIS FINGER AGAINST ANOTHER ROCK.

EE WAS WORKING WITH OTHER EES TO LOAD BORE HOLES FOR BLASTING. EE LAID DOWN ON GROUND TO CHECK 2 BORE HOLES FOR WATER. HE PLACED HIS LEG IN FRONT OF RIGHT FRONT WHEEL OF PRILL TRUCK. WHEN THE PRILL TRUCK PULLED FORWARD TO THE NEXT HOLE, IT RAN OVER HIS LEG.

EE WERE UNBOLTING HEADACHE RACK ON TRUCK TO LOWER IT. WHEN LAST BOLT WAS REMOVED IT FELL ON TOP OF EE.

EMPLOYEE WAS USING A BAR TO LINE UP BOLT HOLES ON A SHAKER UNIT. HE STRAINED HIS BACK.

EE WAS ASSISTING ANOTHER EE IN PREPARING A PLATE FOR INSTALLATION INTO A CONE CRUSHER. HIS FOOT SLIPPED OFF THE PLATE AND HIS STRUCK THE PLAT. NO LOST TIME--STITCHES WERE REQUIRED.

EMPLOYEE ALLEGES THAT HE WAS WORKING ON A MOTOR FOR A TEREX TRUCK WHEN PAIN STARTED IN HIS BACK.