A worker was helping put tin on the roof of a new shed that was being built on the surface near a new fan location that was enclosing some electrical enclosures. EE went to pick up on the cables that were coming out the mast to slide a piece of roof tin under them and felt a tear and heard a pop sound in right arm. EE tore the ligament that attaches the bicep to the elbow.
MOBILE OPERATOR TURNING INTO A 3 TO 2 AND WAS PINCHED BETWEEN MOBILE AND RIB
Roof fall in the #3,#2,#1 entry at 40 x-cut of the A-butt section. Roof fall was above anchorage and blocking our secondary escape way.
tramming scoop and jammed head into roof causing pain in neck
Crawling back to move up bolter and twisted left knee.
employee was putting supplies on his bolter, when he turned he felt a sharp pain in his knee
Roof fall at 19 cross cut 5 belt across 2-4-5 entry.
Miner was dumping duster out of scoop bucket and had his hand on scoop kitchen and went to swing scoop and smashed his finger between stop and scoop frame.
Backing scoop and caught left hand between stop and kitchen. Smashed little finger and ring finger.
Miner was driving a pin on a piece of equipment and struck left hand hurting pinkie finger.
Miner was cleaning a gob out on outside screen with a rock bar when a rock fell striking the back of his left hand.
#1 entry on #1 belt between #14 and #15 cross cut on the left inby rib. 30' long x 8' wide x 3' high. 1 bolt was broke off, approx. 8 bolts exposed and 1 bolt out. The bolts are 42"" fully grouted.
Roof fall on old works on 5A belt. It was at 14brk in the #1 entry. It was approx. 30' long approx. 6' high and approx. 20' wide. this is a continuation of a prior fall.
Roof fall on #6 beltline between 17brk and 19brk approx. 70' long 4' high and 20' wide
A roof fall approx. 40' inby the highwall face of the #3 beltline entry. It's approx. 20' wide 50' long and unknown height.
Roof fall at 22 break in #3 belt entry 50' long 20' wide and approx. 6' high
The roof fell in on #41 break #7 belt in the ""A"" mains in #5 entry approx. 70' long 20' wide and 6' tall
The roof fell in on 41 break #7 belt in the ""A"" mains in #5 entry appox. 70' long 20' wide and 6'tall
a roof fall was discovered around 14 break on 7 belt approx 6' high 60' long in #2-#1 intersection over into #1 entry.
A 30' x 25, x 4' thick roof fall occurred in the mains at break 18 in the #5 intake entry. The fall will not be cleaned up. The area was breakered and additional cribs set in area.
EE was drilling a hole for the inside bolt, a piece of draw rock approximately 7' x 1' x 0"" to 2"" thick fell from the roof striking the injured on the head. The accident occured in the 3 left section in the No. 3 entry crosscut left.
Employee was bolting roof in 4 Right at break no. 35. Top rock fell and struck him on head and left shoulder.
EE was riding mantrip out of the mine, he observed a piece of slate falling from roof. When moved to dodge the falling rock, his leg went out of mantrip and hit the bottom, breaking his leg.
The roof fell in the 2 Left Submains at break #25 in the #4 Entry. The fall is 20 ft. wide by 100 ft. long to the left and right of the intersection.
Injury was feeling for a bolt location on the continuous miner, cut his finger on a broken bolt.
Roof fall occured in a crosscut of a clay vein fault area intersections where cable bolted. The fall occured in a worked out section of the mine where no work is being done.
A roof fall occurred in the No. 1 Return Entry, North East Mains. The fall is 20' x 30' x 8' high at the highest point.
A roof fall occurred at #14 cross-cut, roadway entry of the South Mains. The intersection fell 42 inches high, 20 feet wide and 20 feet long.
A 15' x 12' x 4' thick roof fall occurred at 15 crosscut between roadway and return in the south mains.
Employee was bolting roof when a rock fell hitting his hand on the control lever. Lacerated right ring finger.
EE was changing drill steel. The up lever for the pod was activated instead of the down, pinching and cutting his left index finger.
A roof fall occurred in an abandoned area of 1 Left Panel at #20 Break in the #1 Entry.
A 20' x 60' x 4' to 5' thick roof fall, pulling roof bolts, occurred at breaks 85, 86 and 87 at the No. 1 and No. 2 entries of the South Mains.
A 20'x 20'x 4' to 5' thick roof fall, pulling roof bolts, occurred at the intersection of break 82 in No. 3 entry of the South Mains.
The No. 4 intake entry fell at the highwall, 12 ft. high and 8 ft. into the mine, crushing the end of the fan house.
EE was opening the 1st set of airlock doors, when door slammed shut on his hand.
Roof fall at break 53 of 1 left submain in No. 5 intake airway entry. Fell approximately 20' x 30' x 10'-12' thick. Intersection had a clay vein in middle.
Miner cut into unmapped workings of an abandoned mine in the No. 2 crosscut right of the 9 Left Panel. Water flowed into the active workings and the miners immediately evacuated to the surface. Water pooled outby in No. 5 entry approximately 8"" deep between No. 32 and No. 46 crosscuts. Flow from old mine has stabilized at approximately 15 GPM.
EE was moving debris with drill pot, finger was pinched between feed jack and drill pot arm.
EE was tramming a scoop under a low hanging cable. He lifted the cable with his left arm while tramming under cable. When he was completely under the cable vertically, it shoved his elbow down into the deck putting pressure on his arm.
Employee was operating roof bolter when a hydraulic hose blew, spraying oil in his face (medical only).
Employee was bending a roof bolt and hurt right shoulder.
EE was operating continuous miner when a piece of rock fell from the roof, pinning him against the control levers of the miner.
Fall in intersection at BK7 on 1 lt panel. It fell above anchorage. It was abandoned area. Fall was 20'w x 7'+h, x 75'l.
Employee had his right hand on the drill pot while swinging the boom and accidently hit boom lift lever.
Employee was shoveling belt, slipped and all his weight went on his left wrist.