GRIFFIN QUARRYMetal/Nonmetal

Employee was operating a loader when they alleged they hit a pothole that jarred their back.

While welding the employee noticed irritation to one eye and realized EE had something in EE's eye.

Employee was helping install a cone crusher ram cylinder when it slipped and caused a contusion to their left hand.

Employee was accessing a secondary crusher platform to inspect a crusher when a rock fell from an overhead conveyor striking the employee in the back of the head.

Employee claimed that employee kneeled on a rock while employee was washing out and injured the knee.

Trespasser wrecked a four wheeler within the plant's stockpile area.

The miner was loading cribbing material, 30-40lbs per, into the bed of service truck when the rope handle attached to the cribbing wrapped around the tip of right middle finger. The miners right middle finger from first joint to tip was broken and degloved.

The employee was attempting to remove a pin from the loader bucket, when striking the pin, a piece of metal came off striking them in the neck causing a laceration.

Employee was working on the 990 loader door safety latch. When he reached toward the door to remove a nut which was directly in front of him he felt a pop in his right shoulder.

Employee was changing a hydraulic line when he reached for a bolt to tighten and felt a pop in his left shoulder.

EE was cutting a piece of metal when slag burned through his pants and fell inside of his boot burning the top of his foot.

Employee was installing a table bushing. Bushing became stuck on the second piece of drill steel. As the employee was aligning the piece of drill steel to lower, the bushing fell approximately six inches pinning his left pinky and ring finger between the table and bushing, resulting in fourteen stitches.

Employee was changing out belts on a conveyor drive motor, when the metal railing he had the come-along attached to broke, causing his finger to be pinched between the belt and pulley. The injury required stitiches.

Walking & stepped on a rock and fell back, leg bent back, hurt knee.

EE WAS ABOUT TO HOOK A CRANE TO THE TOGGLE PLATE FROM THE JAW CRUSHER. THE TOGGLE PLATE ROLLED IN ITS SEAT AND FELL ON BOTH OF HIS FEET PINNING HIM UNDER IT. THE PLATE WAS NOT BLOCKED UP. THE PLATE WAS LIFTED OFF OF HIM AND HE WAS TRANSPORTED TO THE E.R. VIA AMBULANCE.

EE WAS BEGINNING TO HOIST AN I-BEAM USING A CHAIN HOIST WHEN THE LOAD SHIFTED AND THE I-BEAM ROLLED COMPLETELY OVER FALLING ON THE TOP OF HIS FOOT.